NC252MP

Stereo power amplifier module with SMPS self contained power supply. Max output power Wrms: 2x180W (2Ω), 2x250W (4Ω), 2x200W (8Ω).

The NC252MP amplifier module incorporates a low power standby power supply (meets 2013 ERP Lot 6 0.5W requirements), a highly efficient switch mode power supply and a high-performance Class D amplifier in one compact and easily applicable power brick.

The amplifier used in the NC252MP is a self-contained high-performance class D amplifier intended for a wide range of audio applications, ranging from public address systems to ultrahigh-fidelity replay systems for studio and home use. Chief distinguishing features are flat frequency response irrespective of load impedance, nearly frequency independent distortion behaviour and very low radiated and conducted EMI.

Control is based on a phase shift controlled self-oscillating loop taking feedback only at the speaker output.

The main SMPS providing the power for the amplifier is a compact, high power, highly efficient, regulated half bridge converter with synchronous rectification on the main output rails. These properties make this technology ideal for powering Class D audio amplifiers.

For applications requiring a standby mode, a low power standby SMPS also has been integrated on this product. To achieve universal mains input compatibility this SMPS features an automatic input voltage doubler. High Line Input Voltage: 190-250Vac, Low Line Input Voltage: 95-130Vac.

The Hypex Channel Extension connector provides for an additional low power tweeter amplifier channel (NC100HF).  

HYPEX NC252MP
  • Max ouput power: 2x180W(2Ω), 2x250W (4Ω), 2x200W (8Ω)

  • Max ouput power BTL: 400W (4Ω), 500W (8Ω)

  • Distorsion THD + N: 0,0015% (20Hz<f<20kHz, 4Ω. Pout<PR/2)

  • Power Bandwidth 20-35Khz

  • Frequency Response  10hz-50Khz  (+0/-3dB. All loads.)

  • Voltage Gain 25,5db

  • Input Impedance 47Kohm 

  • SNR 121

  • Output noise 30mV

  • CMRR 71db all frequency

  • Maximum output current: 17,5A

This two channel amplifier can be utilized in Bridge Tied Load configuration. In this configuration the max output power mono is: 400W((4Ω), 500W (8Ω). This is especially useful for high impedance loads. In a bridge-tied load configuration, the load impedance which each amplifier channel ‘sees’ is half the characteristic impedance of the connected speaker. Therefor the minimum load in BTL configuration is 4Ω, however, we recommend to use only a BTL configuration with a load of 8Ω or higher.

APPLICAZIONI - APPLICATIONS
  • Audiophile power amplifiers

  • Multichannel and home theatre solutions

  • ​Monitor loudspeakers for recording and mastering studios

  • Active loudspeakers

  • PA systems

POWER AMPLIFIERS BASED ON THIS BOARD 

Copyright © 2013-2019  Rouge Audio Design.